Watermark Image

No upload · runs in your browser

Runs entirely in your browser, nothing is uploaded.

How it works

Add a Watermark to Photos : Text or Logo, Placed or Tiled

Stamp text or a PNG logo onto photos. Pick one of nine anchor positions or tile the mark across the frame, set the opacity, then run a whole folder.

What this does
  • Text marks with a colour picker and a size from 2% to 22% of the image’s shorter edge
  • Or a PNG logo, scaled from 5% to 60% of the image width
  • Nine anchor positions, inset from the edge by 4% of the shorter side
  • Opacity from 5% to 100%, plus a tilt from −90° to 90° in 5° steps
  • Tiled mode repeats the mark with alternate rows offset, capped at 3,000 stamps per image
  • Saves as JPEG, PNG or WebP, with a quality slider for the two lossy ones
  • Composited on a canvas in this tab, so the unwatermarked original never leaves the machine
FAQ

It is painted into the pixels, so there is no layer to switch off, but that is not the same as protection. A mark sitting in one corner can be cropped away in seconds, and a faint one can be painted over by anyone patient. Tiled mode at a low opacity is the honest answer to that: covering a mark repeated across the whole frame means damaging the picture. Treat it as a deterrent and a claim of authorship rather than a lock.

Keep going